1消費流程
1. Consumption process
1.1煙氣脫硫系統由下列主要子系統組成：
1.1 the flue gas desulfurization system is composed of the following main subsystems:
(1)煙氣系統
(1) Flue gas system
(2)二氧化硫吸收系統
(2) Sulfur dioxide absorption system
(3)石灰石漿液制備系統
(3) Limestone slurry preparation system
(4)石膏脫水系統
(4) Gypsum dehydration system
(5)工藝水系統
(5) Process water system
(6)緊縮空氣系統
(6) Compressed air system
(7)廢水系統和漿液排空系統
(7) Waste water system and slurry emptying system
(8)電氣及照明系統
(8) Electrical and lighting system
(9)控制系統
(9) Control system
(10)消防及火災報警系統
(10) Fire fighting and fire alarm system
系統描繪
System description
煙氣系統：煙氣系統的主要功用是將由鍋爐側主煙道內的原煙氣引入吸收塔，脫硫凈化后的凈煙氣引入煙囪排放。
Flue gas system: the main function of the flue gas system is to introduce the raw flue gas from the main flue at the boiler side into the absorption tower, and the net flue gas after desulfurization and purification is introduced into the chimney for discharge.
吸收塔系統：煙氣從吸收塔中下側進入與上側噴淋的石灰石漿液逆流接觸，在塔內停止化學反響，對落入吸收塔漿池的反響物再停止氧化反響，得到脫硫副產品二水石膏。經吸收劑洗濯脫硫后的清潔煙氣，經過除霧器除去霧滴后由吸收塔上側引出，排入煙囪。
Absorption tower system: the flue gas enters from the lower side of the absorption tower and contacts with the limestone slurry sprayed on the upper side countercurrent, stops the chemical reaction in the tower, and stops the oxidation reaction on the reactants falling into the slurry pool of the absorption tower, so as to obtain the desulfurization by-product dihydrate gypsum. The clean flue gas washed with absorbent and desulfurized is led out from the upper side of the absorption tower and discharged into the chimney after the mist drops are removed by the demister.
石灰石漿液制備系統：粒徑為325目（經過率大于90％）的石灰石粉由汽車泵送入石灰石粉倉，再經星形給料機由螺旋稱重給料機保送到石灰石漿液箱內，在石灰石漿液箱中加水制成約20-30％的石灰石漿液，然后經石灰石漿液泵送*吸收塔。
Limestone slurry preparation system: limestone powder with a particle size of 325 mesh (passing rate greater than 90%) is pumped into the limestone powder silo by the car, and then transported to the limestone slurry tank by the spiral weighing feeder through the star feeder. Water is added into the limestone slurry tank to make about 20-30% limestone slurry, and then pumped to the absorption tower through the limestone slurry.
系統設兩座鋼制石灰石粉貯倉，貯倉的總?cè)萘堪磧膳_(tái)鍋爐在BMCR工況下運轉3天的石灰石粉耗量設計，有效容積為2*1100m3。每個石灰石粉倉設兩個出料口，各對應1臺星形給料機及一臺螺旋稱重給料機。
The system is equipped with two steel limestone powder silos. The total capacity of the silos is designed according to the limestone powder consumption of two boilers operating for 3 days under BMCR working condition, and the effective volume is 2*1100m3. Each limestone powder bin is equipped with two discharge ports, each corresponding to a star feeder and a spiral weighing feeder.
石灰石漿液箱的有效容積滿足兩臺鍋爐BMCR工況下6小時用量，有效容積為2*300m3。共設四臺石灰石漿液泵，每個吸收塔兩臺，一運一備。兩漿液箱間設聯絡管兩側制漿系統可互為備用。
The effective volume of limestone slurry tank meets the 6-hour consumption of two boilers under BMCR working condition, and the effective volume is 2*300m3. There are four limestone slurry pumps, two for each absorption tower, one for operation and one for standby. A connecting pipe is set between the two slurry tanks, and the pulping systems on both sides can be standby for each other.
工藝水系統：工藝水系統能滿足FGD安裝正常運轉和事故工況下脫硫工藝系統的用水。工藝水系統可向下列設備供水：
Process water system: the process water system can meet the water consumption of FGD process system under normal operation and accident conditions of FGD installation. The process water system can supply water to the following equipment:
（1）吸收塔除霧器沖洗。
(1) Wash the demister of the absorption tower.
（2）石灰石制漿和吸收塔氧化風冷卻及漿池液位調整。
(2) Limestone pulping and oxidation air cooling of absorption tower and liquid level adjustment of slurry pool.
（3）石膏及真空皮帶脫水機沖洗。
(3) Wash gypsum and vacuum belt dehydrator.
（4）脫硫系統設備冷卻、密封及管道沖洗。
(4) Equipment cooling, sealing and pipeline flushing of desulfurization system.
（5）其他用水。
(5) Other water.
工藝水系統為母管制，2臺爐脫硫公用；工藝水泵按2*100％容量設計，除霧器沖洗水泵按3*100％容量設計。工藝水系統母管和除霧器沖洗水母管之間設有手動聯絡門，運轉時開啟進步了系統用水牢靠性。
The process water system is the main pipe, and the desulfurization of two boilers is common; The process water pump is designed as 2*100% capacity, and the demister flushing water pump is designed as 3*100% capacity. A manual connection door is set between the main pipe of the process water system and the flushing water main pipe of the demister, which is opened during operation to improve the reliability of the water used in the system.
石膏脫水及儲存系統：吸收塔內的石膏漿液經過石膏漿液排出泵送入石膏漿液旋流器濃縮，濃縮后的石膏漿液自流***真空皮帶脫水機停止脫水。脫水后外表含水率小于10％，純度達90%以上的石膏送入石膏堆料間儲存外運。
Gypsum dehydration and storage system: the gypsum slurry in the absorption tower is sent to the gypsum slurry cyclone for concentration through the gypsum slurry discharge pump, and the concentrated gypsum slurry flows by itself * * * the vacuum belt dehydrator stops dehydration. After dehydration, gypsum with a moisture content of less than 10% and a purity of more than 90% is sent to the gypsum stacking room for storage and outward transportation.
設兩臺真空皮帶脫水機，每臺出力按兩臺鍋爐BMCR工況下燃用設計煤種時FGD石膏總產量的75％配置，出力為53.1t/h。
Two vacuum belt dehydrators are set, and the output of each one is configured according to 75% of the total output of FGD gypsum when two boilers burn design coal under BMCR working condition, with the output of 53.1t/h.
The above is a detailed introduction about biogas desulfurization, which I hope will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.sxyxzj.com
魯公網安備37011202000764號號 網站地圖XMLTXT
企業二維碼
2022-07-18
